When setting Digital Boundary Microphones asfollows:Main video cameraR ch L chMIC 2MIC 3MIC 1DisplaySpeaker SpeakerConnectorMIC 1: "Right side"MIC 2: "Center Mono"MIC 3: "Left side"Note• Make some noise near the Digital BoundaryMicrophone. " " is displayed to indicatewhich Digital Boundary Microphone picksup the noise.• " " is not displayed when the DigitalBoundary Microphone is mute.• " " is not displayed when multiple DigitalBoundary Microphones pick up the sound atthe same time.• When the Digital Boundary Microphone ismute, the sound made by pressing the MICMute button might make " " appear.5. Press [G].• A dialogue box to confirm the saving of settingsis displayed.6. Use [ ][ ] to select "Yes" and press [ENTER].• The system settings screen is displayed.Note• Do not move Digital Boundary Microphonesafter completing settings. Otherwise thesettings will not match the location of the DigitalBoundary Microphone.Making Remote ControlSettingsYou can specify a remote control ID from 1, 2, or 3 forboth the remote control and the unit. The unit respondsto signals from any remote control with the same remotecontrol ID as itself. If you do not specify an ID, the unitresponds to signals from all remote controls. You canconfirm the remote control ID for the unit on the Homescreen (Page 38).1. Select "Remote Ctrl ID" and press [ENTER].• The remote control settings screen is displayed.2. Use [ ][ ] to select the following items for input:"Remote ID enable": Use [ ][ ] to select"ON" or "OFF" (default).• When "ON" is selected, you can set a specificremote control ID for the unit.• When "OFF" is selected, the unit will respondto all remote controls."Remote control ID": Use [ ][ ] to select aremote control ID ("ID1" [default]/"ID2"/"ID3") forthe unit."Check ID mismatch": Use [ ][ ] to select"ON" (default) or "OFF".• When "ON" is selected, if the unit receives asignal from a remote control that has an IDdifferent from the one specified on the Homescreen, a warning is displayed. Follow theprocedures on the screen to change the remotecontrol ID.• When "OFF" is selected, even if the unitreceives a signal from a remote control that hasan ID different from the one specified, nowarning is displayed on the Home screen.Note• If multiple remote controls with assignedIDs are being used close together, it isrecommended that you select "OFF" for"Check ID mismatch".3. Press [G].• A dialogue box to confirm the saving of settingsis displayed.4. Use [ ][ ] to select "Yes" and press [ENTER].5. When "Remote ID enable" is set to "ON":The dialogue box for changing the ID of the remotecontrol is displayed. Proceed to step 6.116 User Manual Document Version 2015-12Contacts and Settings
