Panasonic M2X Series Instruction Manual

Panasonic M2X Series Instruction Manual Manual pdf 45 page image

- -45Detailed Parameter DescriptionFunction of parameterNo. Parameter name DescriptionSet frequency(0th speed)Used to specify desired operating frequency.Enabled when [ Frequency command selection] is set to .1st speed frequency2nd speed frequency3rd speed frequency4th speed frequency5th speed frequency6th speed frequency7th speed frequency8th speed frequency9th speed frequency10th speed frequency11th speed frequency12th speed frequency13th speed frequency14th speed frequency15th speed frequencyUsed to specify frequency for multi-speed operation.Enabled when [ Operation mode selection] is set to 4-, 8- and 16-speedoperation modes.Run commandselectionRun command can be selected through the following control facility.● (PaNeL) : RUN switch on the operation panel● (TERminal) : Input terminal [IIII1]/[IIII2]■ (BOTH) : Both operation panel and input terminals canbe used.● (SIG) : RS485 communication* When is selected, the input terminal cannot be used for runcommand.Frequency commandselectionUsed to select whether [ Set frequency (0th speed)], frequency setting inputterminals (FIN1 and FIN2) or the inverter’s control dial is used for the 0th speedfrequency setting.■ [ Set frequency (0th speed)]● Analog commandFIN1 (Voltage command) 0 to 5 VDCFIN2 (Current command) 4 to 20 mA● Analog commandFIN1 (Voltage command) 0 to 10 VDCFIN2 (Current command) 4 to 20 mA● Inverter’s control dial∗ If is selected for the inverter that is not equipped with the controldial, the 0th speed frequency setting is disabled.■: Factory settingOperationmode I3 I4 I5 I62-speedmodeCCWjogging CW jogging4-speedmodeSelect among:free-run, external forced trip,No.2 acceleration/decelerationand trip reset.8-speedmodeFrequency settingselection16-speedmode