Panasonic PT-AE100E Operating Instructions Manual

Also see for PT-AE100E: Service manual

ENGLISH-11 Preparation10-E NGLISHAbout the screenIf the screen you are using is dirty, damaged or discoloured, attractiveprojections cannot be obtained. Do not apply any volatile substances to thescreen, and do not let it become dirty or damaged.Before carrying out cleaning and maintenance, besure to disconnect the power cord plug from thewall outlet.Wipe the cabinet with a soft, dry cloth.If the cabinet is particularly dirty, soak the cloth in water with a small amountof neutral detergent in it, squeeze the cloth very well, and then wipe thecabinet. After cleaning, wipe the cabinet dry with a dry cloth.If using a chemically-treated cloth, read the instructions supplied withthe cloth before use.Do not wipe the lens with a cloth that is dusty or which produces lint.If any dust or lint gets onto the lens, such dust or lint will be magnified andprojected onto the screen. Use a blower to clean any dust and lint from thelens surface, or use a soft cloth to wipe off any dust or lint.Precautions on handlingCautions regarding transportationBe sure to attach the lens cover before transporting the projector.The projection lens is extremely susceptible to vibration and shocks. Whencarrying the projector, use the accessory carrying bag.When placing the projector inside the carrying bag, position it sothat the lens is facing upward.Cautions regarding setting-upObserve the following at all times when setting up the projector.Avoid setting up in places which are subject to vibration or shocks.If the projector is set up in locations with strong vibration, such as near amotor, or if it is installed inside a vehicle or on board a ship, the projectormay be subjected to vibration or shocks which can damage the internal partsand cause malfunctions or accidents. Accordingly, set up the projector in aplace which is free from such vibrations and shocks.Do not set up the projector near high-voltage power lines or nearmotors.The projector may be subject to electromagnetic interference if it is set upnear high-voltage power lines or motors.If installing the projector to the ceiling, ask a qualified technician tocarry out all installation work.If the projector is to be suspended from the ceiling, you will need to purchasethe separate installation kit (Model No.: ET-PKE100). Furthermore, allinstallation work should only be carried out by a qualified technician.If using of this projector at high elevations (above 1400 m), consultyour dealer or Authorised Service Centre.Special measures will be necessary to use this projector at high elevations,so consult your dealer or Authorised Service Centre about preparations.Failure to observe this may cause malfunctions.Notes on useIn order to get the best picture qualityIf outside light or light from indoor lamps is shining onto the screen, theimages projected will not have good contrast. Draw curtains or blinds overany windows and turn off any fluorescent lights near the screen to preventreflection.Do not touch the surfaces of the lens with your bare hands.If the surface of the lens becomes dirty from fingerprints or anything else, thiswill be magnified and projected onto the screen. Moreover, when not usingthe projector, retract the lens and then cover it with the accessory lens cover.