Panasonic PT-AE2000E Operating Instructions Manual

Also see for PT-AE2000E: Spec file Brochure & specs Service manual Service manual

Contents

Basic OperationRemote control operation24 - ENGLISHYou can display the image brightness andcontrast level of the input signal with awaveform. See “WAVEFORM MONITOR”on page 32.J Displaying the waveform1. Press the WAVEFORM button and display thewaveform monitor.Press the WAVEFORM button again to escape fromthe waveform mode.2. Press ENTER button until the required waveformoption is displayed.In FULL SCAN mode, press F G I H to changethe waveform position.In SINGLE LINE SCAN mode, press F G to selectthe required line position.J Adjustment exampleProject a commercial test signal for pictureadjustment on the screen and press theWAVEFORM button.Q Adjusting with luminance options1. Press the ENTER button until FULL SCAN(Y)/SINGLE LINE SCAN(Y) is displayed.2. Press the PIC. ADJUST to display the PICTUREMODE of the PICTURE menu.3. Press G several times to display theBRIGHTNESS.4. Adjust the BRIGHTNESS by pressing I H.Adjust the bottom line of the waveform to 0%(0 or 7.5 IRE).Setting range: -32 to +325. Press G once to display the CONTRAST.6. Adjust the CONTRAST by pressing I H.Adjust the bottom line of the waveform to 100%(100 IRE).Setting range: -64 to +64Adjusting the signal condition with a waveformFULL SCANMonitoring the waveform ofbrightness and contrast of the wholeimage.SINGLE LINE SCANMonitoring the waveform ofbrightness and contrast in eachhorizontal line of the image.100%50%0%100%50%0%100%50%0%ENTERENTEROptimaldynamic rangeAdjust to 100%Adjust to 0% Monitor positionOptimaldynamic rangeAdjust to 100%Adjust to 0% Monitor positionCOMPUTER (except 1080)HDMI (Expand)Signal levelSignal levelFULL SCAN(Y) SINGLE LINE SCAN(B)FULL SCAN(R) SINGLE LINE SCAN(G)FULL SCAN(G) SINGLE LINE SCAN(R)FULL SCAN(B) SINGLE LINE SCAN(Y)NOTE:• In SINGLE LINE SCAN mode, the position of thewaveform monitor depends on the position of theselected line.• You can display the main menu by pressing the MENUbutton and adjust the menu items.• The called up menu items displayed position dependson the position of the waveform monitor.• You can activate AUTO ADJUST of the WAVEFORMmenu by pressing the DEFAULT button.• The signal which is lower than 0% in the waveform willbe displayed as same as 0% on the projected image.• While the waveform is displayed, the image isdisplayed without the COLOUR MANAGEMENTadjustment.• When adjusting the KEYSTONE of the POSITIONmenu while the waveform is displayed, xvYCC will bedeactivated.FULL SCAN(Y)/SINGLE LINE SCAN(Y)BRIGHTNESS Adjust the bottom line of thewaveform to 0% (0 IRE or 7.5 IRE)CONTRAST Adjust the top line of the waveformto 100% (100 IRE)