Panasonic PT-AE8000U Operating Instructions Manual

Also see for PT-AE8000EA: Service manual

Contents

Panasonic PT-AE8000U Operating Instructions Manual Manual pdf 41 page image

[PICTURE] menuENGLISH- 41 Settings[COLOR TEMPERATURE]You can adjust the color temperature if the whiteareas of the projected image are bluish or reddish.Less bluish Less reddishz Setting range: -6 to +6[SHARPNESS]With regards to the input signal, adjust videosharpness using one of [SIMPLE] which adjustshorizontal direction and vertical directionsimultaneously or [ADVANCED] which adjusts eachindividually.Softer SharperNotez Setting range will vary according to the selected inputsignal.z [SHARPNESS] can be adjusted using either [SIMPLE] or[ADVANCED]. Both settings cannot be used at the sametime.z Adjusting the [SHARPNESS].(When [SIMPLE] is selected for the[ADJUSTMENT MODE].)1) Press▲▼ buttons to select [SIMPLE].SHARPNESSADJUSTMENT MODESHARPNESSH-SHARPNESSV-SHARPNESSSIMPLE0PICTUREPOSITIONLANGUAGE3D SETTINGSLENS CONTROLOPTION2) Select [SHARPNESS] with the ▲▼buttons, and adjust with the▲▼ buttons.z Adjusting the [SHARPNESS].(When [ADVANCED] is selected for the[ADJUSTMENT MODE].)1) Press the ◄► buttons to select[ADVANCED].SHARPNESSADJUSTMENT MODESHARPNESSH-SHARPNESSV-SHARPNESSADVANCED00PICTUREPOSITIONLANGUAGE3D SETTINGSLENS CONTROLOPTION2) Select item with the ▲▼ buttons, andadjust with the▲▼ buttons.z Pressing the ▲▼ buttons on the screen duringadjustment switches to the [H-SHARPNESS] or[V-SHARPNESS] adjustment screen.H-SHARPNESSV-SHARPNESS00z The setting range varies according to the selectedpicture mode and input signal.[DYNAMIC IRIS]You can switch automatic adjustment of the lamp andthe lens iris on/off. This augments the video to createa video expression with sharp contrast between lightand shade.Switch settings Switch settings[ON] Automatic adjustment[OFF] No adjustment[WAVEFORM MONITOR]By using a commercial test disk etc. and setting theluminance level of the output (brightness) signal froma connected external device to a value within thisprojector’s recommended range, you can performadjustment so the display performance of the projectorcan be fully leveraged.1) Press the button.z The [WAVEFORM MONITOR] menu is displayed.WAVEFORM MONITOROFFFULL SCAN(Y)FULL SCAN(R)FULL SCAN(G)FULL SCAN(B)SINGLE LINE SCAN(Y)SINGLE LINE SCAN(R)SINGLE LINE SCAN(G)SINGLE LINE SCAN(B)MONITOR POSITIONAUTO ADJUSTUPPER LEFT2) Press the ▲▼ buttons to select therequired item.z Select [OFF] to close the waveform monitor.3) Press the button.z The waveform monitor is displayed.Notez For details, see “Displaying the waveform monitor” in“Remote control operation”. ( page 33)