Panasonic PT-AE8000U Operating Instructions Manual

Also see for PT-AE8000EA: Service manual

Contents

Panasonic PT-AE8000U Operating Instructions Manual Manual pdf 80 page image

[OPTION] menu80 - ENGLISHSettings• [BLANK]When [BLANK] is activated, output is 12 V. If thesetting is released, output is 0 V.• [RS-232C COMMAND LINK]Receives commands ( page 103) from external deviceand outputs 12 V.z Input[POWER ON/OFF] [BLANK]• [POWER ON/OFF]If the trigger input signal from the external device ischanged from 0 V to 12 V, the projector power will beswitched on. And if it is changed from 12 V to 0 V, thepower will be switched off.• [BLANK]If the trigger input signal from the external device ischanged from 0 V to 12 V, the screen will go blank. Andif it is changed from 12 V to 0 V, the [BLANK] settingwill be released.3) Press the ▲▼◄► buttons to move thecursor to [DELAY TIME]4) Press the ◄► buttons to set the delaytime for the trigger output signalz The delay time can be set to 2, 4, 6, 8, 10, 20, and30 seconds.z It is possible to delay the trigger output signal (12 V)by the amount of time set. (Only available if triggeroutput item is selected.)E.g.) Select [SELECT 4:3 ASPECT] of the trigger outputfunction and set the delay time to 10 seconds.Set the [ASPECT] in the [POSITION] menu to [4:3],and 12V is output from the trigger port after 10seconds.Notez You should not use trigger terminal output as the powersource for other devices.z The projector will not accept trigger input while preparingto project after the power has been switched on andwhile preparing to shutdown after projection. Input triggersignals after projection starts or after entering standbymode.z 12 V cannot be output from the trigger terminal when theprojector is in standby mode.[SLEEP]Set the time for the power to be automatically turnedoff.Switch settings Switch settings[OFF] Inactive[60MIN.] Turn power off after 60 minutes[90MIN.] Turn power off after 90 minutes[120MIN.] Turn power off after 120 minutes[150MIN.] Turn power off after 150 minutes[180MIN.] Turn power off after 180 minutes[210MIN.] Turn power off after 210 minutes[240MIN.] Turn power off after 240 minutesNotez The projector automatically enters power off preparationmode (the power indicator illuminates orange), and thenenters standby mode (the power indicator illuminates orflashes in red). ( page 28)z 3 minutes before turn-off, the number of minutesremaining will be displayed in the lower right corner.z If [SLEEP] mode is set to [OFF] mode before thespecified time has elapsed the settings are erased.[HIGH ALTITUDE MODE]Set to [ON] when using at locations between 1 400 m(4 593 ft) and 2 700 m (8 858 ft) above sea level.Switch settings Switch settings[OFF]When using at an altitude of lessthan 1 400 m (4 593 ft) abovesea level[ON]When using at high altitudes(between 1 400 m (4 593 ft) and2 700 m (8 858 ft) above sealevel)Notez The fan rotation and operating noise increases if set to[ON].