ENGLISH -31Basic OperationProjectingCheck the connections of the peripheral devices and connection of the power cord (page 26) and switch on thepower (page 28) to start the projector. Select the image and adjust the state of the image.Selecting the imageSelect an input signal.The image selected with the , , , button is projected (page 31).AttentionImages may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select asystem format that is suitable for the input signal in [Component] or [RGB] in the [Input] menu (page 40).Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Screen] menu(page 49).How to adjust the state of the imageZoom and Image Position AdjustmentPress the ZOOM +/- buttons on the control panel to adjust the screen size. Screen size can be adjusted 84% to100% from its maximum screen size.It is not available when On-Screen menu is displayed.Zoom adjustment can be memorized.The image position can be adjusted in the Zoom Adjustment by the following steps:Press the ZOOM+ or ZOOM- button on the control panel.1 )While ZOOM+ or ZOOM- is displayed on the screen, press the 2 )on the screen.Press3 )▲▼◄►buttons on the control panel or the remote control to adjust the image position.Note:Zoom and Image Position Adjustment can not be operated when 4:3 or 16:9 mode is selected in the [Screen aspect] menuor [Custom] is selected in the [Screen] menu.The image position adjustment can not be adjusted at ZOOM maximum.The white arrows indicate that there is no correction.A red arrow indicates the direction of correction.An arrow disappears at the maximum correction.Focus AdjustmentAdjust the lens focus with the focus lever.NoteIt is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.If keystone distortion occurs, see “KEYSTONE”. (page 50)Focus Lever