ENGLISH -49SettingsScreenSelect [Screen] from the Main Menu (see“Navigating through the menu” on page 37),then select the item from the sub-menu.Remote ControlControl PanelNormalProvide the image to fit the screen size whilemaintaining the aspect ratio of the input signal.Press ▲▼ to select [Normal] and thenpress the FullProvide the full screen image.Press ▲▼ to select [Full] and then pressthe Wide(16:9)Provide the image at the 16:9 wide screen ratio.Press ▲▼ to select [Wide(16:9)] and thenpress the ZoomScale the image proportionally to fit the entire screen.Either side of image may go over the screen.Press ▲▼ to select [Zoom] and thenpress the TrueProvide the image in its original size. When theoriginal image size is larger or smaller than the panelsize (1280 x 800),*the projector enters to the panningmode automatically.Press ▲▼ to select [True] and then1 )press the Press ▲▼◄► to pan the image.2 )When adjusted, the arrows will turn red. Whenreached to the correction limits, the arrows willdisappear.*Screen size(1280 x 800) is only for PT-CW230EA.Screen size (1024 x 768) is for PT-CX200EA.NoteWhen input computer signal to the projector, [True] willbe available.[True] is disabled and cannot be displayed when [480i],[576i], [480p], [576p], [720p] or [1080i] is selected in thePC System Menu.When [True] is selected in the Screen menu, [Digitalzoom +/-] can not be selected.Natural wide(PT-CW230EA Only)Modify the 4:3 aspect ratio image to fit the screen sizeby stretching the image to make it look natural.Press ▲▼ to select [Natural wide] andthen press the NoteWhen input video signal to the projector, [Natural wide]will be available.[Natural wide] is not available when [720p] or [1080i] isselected in the PC System Menu.CustomProvide the last stored aspect screen image.Press ▲▼ to select [Custom] and pressthe