Panasonic PT-CW230EA Operating Instructions Manual

Also see for PT-CW230EA: Operating instructions Service manual

Contents

Read this first!ENGLISH - 7 ImportantInformationCAUTION:To remove the batteryRemote Control Battery1. Press the guide and lift the cover. 2. Remove the batteries.CAUTION:ON USE/INSTALLATIONDo not put your weight on this projector.You could fall or the projector could break, and injury will result.Be especially careful not to let young children stand or sit on the projector.Do not place the projector in extremely hot locations.Doing so will cause the outer casing or internal components to deteriorate, or result in fire.Take particular care in locations exposed to direct sunlight or near stoves.Always disconnect all cables before moving the projector.Moving the projector with cables still attached can damage the cables, which will cause fire or electric shocksto occur.ACCESSORIESDo not use the old lamp unit.If used it could cause lamp explosion.If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to thebroken pieces.Failure to observe this will cause the user to absorb the gas which was released when the lamp broke and whichcontains nearly the same amount of mercury as fluorescent lamps, and the broken pieces will cause injury.If you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seekmedical advice immediately.Ask your dealer about replacing the lamp unit and check the inside of the projector.POWERWhen disconnecting the power cord, be sure to hold the power plug and power connector.If the power cord itself is pulled, the lead will become damaged, and fire, short-circuits or serious electricshocks will result.When not using the projector for an extended period of time, disconnect the power plug from the walloutlet and remove the batteries from the remote control.Disconnect the power plug from the wall outlet before carrying out any cleaning and replacing theunit.Electric shocks can result if this is not done.