Panasonic PT-D7000E Operating Instructions Manual

Contents

Panasonic PT-D7000E Operating Instructions Manual Manual pdf 33 page image

ENGLISH33Powering up the projectorConnect the supplied power cable.(220 V–240 V, 50 Hz/60 Hz)Press the “I” marked side of the MAINPOWER switch to turn on the power.The power indicator lamp on the projector will flashin red. After a short period, the indicator willilluminate and the projector will enter standbymode.Press the “l” button. [on the main unitor the remote control]The power indicator lamp illuminates in green andsoon the image is projected on the screen.Making adjustment andselectionRoughly adjust the focus of the lens.(Refer to page 35.)Press the LENS button on the main unit or theremote control unit to display a focus adjustmentscreen. Pressing buttons to adjustthe image into focus.Select and set the projection scheme.(Refer to page 65.)Select the input signal by pressing theinput selector button to toggle throughRGB1, RGB2, VIDEO, S-VIDEO andAUX. [on the main unit or the remotecontrol]Adjust the tilt of the main unit in frontand rear or right and left.(Refer to page 18.)Press the LENS button two or threetimes to adjust the lens shift. (Refer topage 35.)• If the projector is powered up at about 0 ˚C, a warm-up period of approximately five minutes may benecessary to start projection.The temperature monitor (TEMP) lamp lights upduring the warm-up period.When the warm-up is completed, the temperaturemonitor (TEMP) lamp turns off and the image isprojected on the screen.• If the surrounding temperature is very low and thewarm-up period exceeds five minutes, the controldetermines it as an abnormal condition and turns offthe power automatically. If this happens, raise thesurrounding temperature to 0 °C or higher and thenturn the main power “on” and turn the power “on” (|).• The AUX button is disabled when an optional inputmodule is not connected.NoteAUTOSETUPRGB 1VIDEOMENU ENTERLENSS-VIDEO SHUTTERRGB 2 AUX-POWERON OFFRGB1 RGB2 AUXMENUSTDLENSOSD1472583690NEXT USERLIGHT ID ALLASPECTID SETProjectorComputerNumetricBRIGHT CONTRASTON SCREENSYSTEMSELFUNC1D.ZOOMENTERPAGE UPPAGE DOWNVIDEO SHUTS-VIDEOFREEZESHUTTERAUTOSETUPLASER ON/OFF-Press the AUTO SETUP button if theinput signal is RGB signal. [on themain unit or the remote control]Fit the image size to the screen size.(Refer to page 35.)Press the LENS button twice and adjust the zoomof the lens on the lens zoom adjustment menu.Press the LENS button and adjust thefocus of the lens on the lens focusadjustment menu.Display the zoom adjustment menuagain and adjust the zoom of the lensto fit the image size to the screen size.(Refer to page 35.)Projection