[PROJECTOR SETUP] menu108 - ENGLISHSettings[RS-232C]Set the communication conditions of the IN>/ terminal.1) Press ▲▼ to select [RS-232C].2) Press the button.▶z The [RS-232C] screen is displayed.3) Press ▲▼ to select an item.▶■ To set the communicationcondition of the terminal4) Select [(IN) BAUDRATE] in Step 3).5) Press ◀▶ to switch [(IN) BAUDRATE].▶z The setting will change as follows each timeyou press the button.[9600] [19200] [38400]6) Press ▲▼ to select [(IN) PARITY].7) Press ◀▶ to switch [(IN) PARITY].▶z The setting will change as follows each timeyou press the button.[NONE] [EVEN] [ODD]▶■ To set the communicationcondition of the terminal4) Select [(OUT) BAUDRATE] in Step 3).5) Press ◀▶ to switch [(OUT)BAUDRATE].▶z The setting will change as follows each timeyou press the button.[9600] [19200] [38400]6) Press ▲▼ to select [(OUT) PARITY].7) Press ◀▶ to switch [(OUT) PARITY].▶z The setting will change as follows each timeyou press the button.[NONE] [EVEN] [ODD]▶■ To set the response4) Select [RESPONSE(ID ALL)] in Step 3).5) Press ◀▶ to switch [RESPONSE(IDALL)].▶z The setting will change as follows each timeyou press the button.[ON] [OFF][ON] Returns the response when the IDsetting is ALL.[OFF] Does not return the response when theID setting is ALL.6) Press ▲▼ to select [GROUP].7) Press ◀▶ to switch [GROUP].▶z The setting will change as follows each timeyou press the button.[A] [B] [Z][A] to [Z]Controls multiple projectorssimultaneously by sending the ID ofRS-232C. Set the group from [A] to [Z].The projector responds when the ID ofRS-232C matches the setting.8) Press ▲▼ to select [RESPONSE(IDGROUP)].9) Press ◀▶ to switch [RESPONSE(IDGROUP)].▶z The setting will change as follows each timeyou press the button.[ON] [OFF][ON] Returns the response when the IDsetting is GROUP.[OFF] Does not return the response when theID setting is GROUP.Notez Refer to “/ terminal”( page 160) for the /terminals and ID transmission in RS-232C.
