[DISPLAY OPTION] menuENGLISH - 89 Settings▶■ To use a colorimeter to adjust thecolor matchingUse a colorimeter that can measure chromaticitycoordinates and luminance to change the colors[RED], [GREEN], [BLUE], [CYAN], [MAGENTA],[YELLOW], and [WHITE] to desired colors.▶zInputting the current luminance andchromaticity coordinates1) Press ▲▼ to select [COLORMATCHING].2) Press ◀▶ to select [709MODE] or[MEASURED].3) Press the button.▶z The [709MODE] or [MEASURED MODE]screen is displayed.4) Press ▲▼ to select [MEASUREDDATA].5) Press the button.▶z The [MEASURED DATA] screen is displayed.6) Measure the luminance (Y) and thechromaticity coordinates (x, y) usingthe colorimeter.7) Press ▲▼ to select a color, and press◀▶ to adjust the setting.▶z Set [AUTO TESTPATTERN] to [ON] to displaya test pattern of selected colors.8) Once all the input is completed, pressthe ▶z The [709MODE] or [MEASURED MODE]screen is displayed.▶zInputting the coordinates of desiredcolors (for [MEASURED] only)9) Press ▲▼ to select [TARGET DATA].10) Press the button.▶z The [TARGET DATA] screen is displayed.11) Press ▲▼ to select a color and press◀▶ to input coordinates for desiredcolors.▶z Set [AUTO TESTPATTERN] to [ON] to displaya test pattern of selected colors.12) Once all the input is completed, pressthe Notez When [709MODE] is selected in [COLORMATCHING], the ITU-R BT.709 standard threeprimary colors are set as target data.z Colors are not displayed properly when target datais a color outside the region of this projector.z The [709MODE] may differ slightly from the ITU-RBT.709 standard colors.z Set the [AUTO TESTPATTERN] to [ON] toautomatically display a test pattern for use inadjusting the selected adjustment colors.z Before using a colorimeter or similar instrument tomeasure measurement data, set [PICTURE MODE]to [DYNAMIC].z A difference in the color coordinates of targetdata and measurement values obtained from aninstrument may occur for certain instruments andmeasurement environments used.z The [AUTO TESTPATTERN] setting s changein conjunction with the [AUTO TESTPATTERN]settings in [EDGE BLENDING].[LARGE SCREENCORRECTION]Corrects the phenomenon in which colors that appearlighter when viewed on a large screen viewed froma close distance compared to when viewed on anaverage screen size so that colors appear the same.1) Press ▲▼ to select [LARGE SCREENCORRECTION].2) Press ◀▶ to switch [LARGE SCREENCORRECTION].▶z The setting will change as follows each timeyou press the button.[OFF] (Nocorrection) [1] (Low) [2] (High)
