|
Remote control operationENGLISH - 59 Basic OperationUsing the STATUS functionYou can display the status of the projector.buttonPress the button on the remotecontrol.▶z The [STATUS] screen is displayed.ENTERMENURGB2XGA60-A848.36kHz/ 60.03Hz140h68h/ ON/69h/ ON/0h/ OFF/0h/ OFF/27°C/ 80°F33°C/ 92°F33°C/ 92°F1/4SEND STATUS VIA E-MAILCHANGE EXITSTATUSINPUTSIGNAL NAMESIGNAL FREQUENCYPROJECTOR RUNTIMELAMP1LAMP2LAMP3LAMP4INTAKE AIR TEMP.OPTICS MODULE TEMP.AROUND LAMP TEMP.REMOTE2 STATUS DISABLENotez This can be displayed from the [PROJECTORSETUP] menu → [STATUS] ( page 109).Using the Automatic setupfunctionThe automatic setup function can be used toautomatically adjust the resolution, clock phase, andpicture position when analog RGB signals consistingof bitmap images such as computer signals are beinginput, or to automatically adjust the picture positionwhen DVI-D/HDMI signals are being input. It isrecommended to supply images with a bright whiteborder at the rims and characters with high contrastblack and white when the system is in the automaticadjustment mode.Avoid supplying images that include halftones orgradation, such as photographs and computergraphics.buttonPress the button on theremote control or the control panel.▶z [COMPLETE] is displayed when it hascompleted without any problem.Notez The CLOCK PHASE may shift even if it hascompleted without any incident. In such cases,adjust with the [POSITION] menu → [CLOCKPHASE] ( page 74).z If an image with blurred edges or a dark image isinput, [INCOMPLETE] may appear or adjustmentmay not be performed properly even if [COMPLETE]appears. In this case, adjust the settings inthe [ADVANCED MENU] menu → [INPUTRESOLUTION] ( page 78), [POSITION] → [CLOCKPHASE] ( page 74), [SHIFT] ( page 72).z Adjust specific signals according to the [DISPLAYOPTION] menu → [AUTO SETUP] ( page 91).z Automatic adjustment may not work depending onthe model of the computer.z Automatic adjustment may not work for asynchronization signal of C-SY or SYNC ONGREEN.z Images may be disrupted for a few seconds duringautomatic adjustment, but it is not a malfunction.z Adjustment is required for each input signal.z Automatic adjustment can be canceled bypressing the adjustment operation.z Even for an RGB signal for which automatic setupis possible, if automatic setup is performed whilemoving images are being input, the adjustment maynot be performed properly. Even if [INCOMPLETE]or [COMPLETE] appears, the adjustment may notbe performed properly.Using the Function button[DISABLE], [P IN P], [SUB MEMORY], [SYSTEMSELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE],[WAVEFORM MONITOR], [LENS MEMORY LOAD],or [LEFT/RIGHT SWAP] operations can be assignedto the button on the remote control so that itcan be used as an easy shortcut button.buttonPress the button on the remotecontrol.Notez [LEFT/RIGHT SWAP] can only be assigned inPT-DZ21KU, PT-DS20KU.z Assignment of the function is performed from the[PROJECTOR SETUP] menu → [FUNCTIONBUTTON] ( page 110).
|
