Chapter 4 Settings — [NETWORK] menuENGLISH - 135[NETWORK] menuOn the menu screen, select [NETWORK] from the main menu, and select an item from the sub-menu.Refer to “Navigating through the menu” (x page 65) for the operation of the menu screen.f After selecting the item, press asqw to set.[NETWORK SETUP]Perform the initial setting of the network before using the network function.1) Press as to select [NETWORK SETUP].2) Press the button.f The [NETWORK SETUP] screen is displayed.3) Press as to select an item, and change the settings according to the operation instructions of themenu.[PROJECTOR NAME] Change the setting when using a DHCP server.[DHCP] Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when notusing a DHCP server.[IP ADDRESS] Enter the IP address when not using a DHCP server.[SUBNET MASK] Enter the subnet mask when not using a DHCP server.[DEFAULT GATEWAY] Enter the default gateway address when not using a DHCP server.[STORE] Save the current network settings.4) Press as to select [STORE], and press the button.5) When the confirmation screen is displayed, press qw to select [OK], and press the button.Notef When using a DHCP server, confirm that the DHCP server is running.f Consult your network administrator regarding the IP address, subnet mask, and default gateway.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL] Set to [ON] to control with the / terminal control command format(x page 172). Refer to “Control commands via LAN” (x page 167).[COMMAND PORT] Set the port number used for command control.[CRESTRON RoomView] Set to [ON] to control with RoomView of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer tothe website of AMX Corporation.URL http://www.amx.com/[STORE] Save the current network control settings.
