Panasonic PT-F100E Operating Instructions Manual

Also see for PT-F100E: Service manual Operating instructions

Contents

Panasonic PT-F100E Operating Instructions Manual Manual pdf 22 page image

ENGLISH - 22Basic OperationSwitching the projector on/offJ Connecting1. Make sure the shapeof the mains plug andthe AC IN connectoron the back of theprojector match, thenpush the plug all the way in.2. Connect the Mains lead to a mains socket.J Disconnecting1. Make sure the MAIN POWER is switched off andunplug the Mains lead from the mains socket.2. Hold the plug and unplug the Mains lead from theAC IN connector on the back of the projector.J Direct power off functionYou can disconnect the Mains lead from theprojector or switch off the MAIN POWER buttonwhile projecting or soon after projecting. Theinternal lamp cooling fan will keep operating by theinternal power supply.J Direct power on functionIf you activate the DIRECT POWER ON, you canstart the projection only with connecting the Mainslead or switching on the MAIN POWER. See“DIRECT POWER ON” on page 37.Mains leadNOTE:• If the projector is switched on again while the internalcooling fan is still operating by the internal powersupply, it may take a while to start the projection.NOTE:• Do not use other than a provided Mains lead.• Ensure all the input devices are connected and turned off before connecting the Mains lead.• Do not force the connector as this may damage the projector and/or the mains lead.• Dirt or dust build-up around plugs may cause fire or electrical hazards.• Switch off the power to the projector when not in use.POWER indicatorIndicator status StatusNo illumination or flashing The MAIN POWER is switched off.REDLitThe MAIN POWER is switched on and the projector is in standby.When the LAMP or TEMP indicator is flashing, the POWER indicator willnot be lit.Flashing Network connection is ready while the POWER is turned off.GREENFlashing The POWER is switched on and the projector is getting ready to project.Lit The projector is ready to project.ORANGELit The POWER is switched off and the projector is cooling the lamp.Flashing The POWER is switched on again when cooling the lamp and recoveringto projection mode. Recovery may take a while.NOTE:• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may takea while to start the projection.• The electric consumption in standby mode is 3 W.POWER indicator