Basic OperationRemote control operationENGLISH - 27When projecting an image, press FREEZE tocapture the projected image and display it onthe screen as a still picture. While the image isfrozen, the sound will be stopped.Press the FREEZE button to return to the projection.You can turn off the lamp and stop theprojection temporary for electrical power save.Press the SHUTTER button to return to the projection.You can reset most of the customised settingsto the factory defaults by pressing theDEFAULT button of the Remote control.Display the required sub menu or the menuitems and press the DEFAULT button again.See “Main menu and Sub-menu” on page 30.You can project an image in split 2 windowsas an INDEX-WINDOW, one is frozen, storedin memory and displayed on the screen’s leftside, while the display of subsequent imagescontinues on the right.To escape from the INDEX-WINDOW, pressthe MENU or RETURN button.Q Switching the positionIn default, the frozen image is displayed on the leftand the subsequent image is displayed on theright. Press I H to switch the position.Q Changing the image sizePress F G to switch and cycle through in 3 size.Q Capturing a new imageWhile in INDEX-WINDOW mode, press ENTER tocapture a new image and the frozen image windowwill be updated in a while.Capturing an imageStopping the projection temporaryResetting to the factory default settingsNOTE:• Some menu items are not available to reset by pressingthe DEFAULT button. Adjust each menu itemsmanually.• To reset all the settings to the factory defaults, see“INITIALISE ALL” on page 38.Projecting an image in INDEX-WINDOW modeProjected image Frozen imageContinuing imageFrozen imageContinuing imageContinuing imageFrozen imageNOTE:• If you change the window size, the aspect ratio of theimage is changed and becomes vertically elongated.Frozen imageContinuing image