Panasonic PT-F300EA Operating Instructions Manual

Also see for PT-F300E: Operating instructions Service manual Service manual

Contents

Panasonic PT-F300EA Operating Instructions Manual Manual pdf 13 page image

ENGLISH - 13 PreparationRead this firstWhen you start the projection for the first time, the minimum required setting screen for projection will be displayed.J INITIAL SETTING1. Select the required language setting by pressingI H, then press the ENTER button.2. Select the minimum required settings to start theprojection.Press the RETURN button to return to the languagesetting menu.Press F G to move through the menu items.Press I H to select the required setting.Press the ENTER button to complete the setting andstart the projection.INSTALLATIONSelect the required installation method.HIGH ALTITUDE MODEIf you use the projector at high elevation, the HIGHALTITUDE MODE setting need to be ON to set the fanspeed high.OFF The fan speed is low.ON The fan speed is high.Minimum required setting screenINITIAL SETTINGENGLISHSELECTENTERPLEASE SELECT LANGUAGEINSTALLATIONINITIAL SETTINGFRONT/DESKHIGH ALTITUDE MODE OFFSELECTENTERRETURNSWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft).FRONT/DESK Setting on a desk/floor andprojecting from frontFRONT/CEILING Mounting on the ceiling andprojecting from frontREAR/DESK Setting on a desk/floor andprojecting from rearREAR/CEILING Mounting on the ceiling andprojecting from rearNOTE:• At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level,the setting must be ON.• The loudness of fan noise depends on the HIGHALTITUDE MODE setting.NOTE:Once you finish the minimum requirement setting, it will not be displayed again unless the projector isinitialised. See “INITIALIZE ALL” on page 45.You can change the each setting from the main menu. See “Menu Navigation” on page 32.