Panasonic PT-FX400U Operating Instructions Manual

Also see for PT-FW430EA: Operating instructions Specifications

Contents

Panasonic PT-FX400U Operating Instructions Manual Manual pdf 56 page image

56 - ENGLISHSettingsPROJECTOR SETUP menuSelect [PROJECTOR SETUP] from the MainMenu (see “Navigating through the menu” onpage 35), then select the item from the sub-menu.After selecting the item, press ◄► to set.zRemote Control Control PanelSTATUSDisplays the status of the projector.Press ▲▼ to select [STATUS].1 )Press the button.2 ) The [STATUS] screen appears.zSIGNAL NAME Displays the input signal name.SIGNALFREQUENCYDisplays the frequency of theinput signal.PROJECTORRUNTIME Displays the projector runtime.LAMP Indicates the number of hoursthe lamp has been usedSERIALNUMBERDisplays the serial number of theprojector.PROJECTOR IDThe projector has an ID number setting function thathelps the user to control two or more projectors eithersimultaneously or separately with a single remotecontrol.Press ▲▼ to select [PROJECTOR ID].1 )Press the button.2 ) The [PROJECTOR ID] screen appears.zPress ▲▼ to select [PROJECTOR ID].3 ) Select [ALL] or a number between [1] and [6]zfrom the list that appears.ALL 16 2Press the button to confirm4 )the entry.The selected [PROJECTOR ID] appears.zNoteIf the projectors are given ID numbers, their remotezcontrols must be assigned the same ID numbers,respectively.If the ID number of a projector is set to [ALL], it can bezcontrolled by the remote control or the PC with any IDnumber.If multiple projectors are used and some of themhave their IDs set to [ALL], they cannot be controlledseparately from the projectors with other ID numbers.For details on remote control ID setting, refer to “SettingRemote control ID numbers” (Æpage 20).INITIAL START UPUse the steps below to select INITIAL START UPwhen the projector is connected to a wall outlet.Press ▲▼ to select [INITIAL START1 )UP].Use ◄► to switch [INITIAL START UP]2 )settings.Each press of the button switches the settingszas shown below.LAST MEMORY STANDBY ONLASTMEMORYStarts up the projector in the mode itwas in when last shut downSTANDBY Starts up in standby modeON Starts projection immediately