Panasonic PT-FX400U Operating Instructions Manual

Also see for PT-FW430EA: Operating instructions Specifications

Contents

Panasonic PT-FX400U Operating Instructions Manual Manual pdf 58 page image

PROJECTOR SETUP menu58 - ENGLISHSettingsSCHEDULEThis sets the command execution schedule for eachday of the week.How to enable the SCHEDULEJfunctionPress ▲▼ to select [SCHEDULE].1 )Press ◄► to switch [SCHEDULE].2 ) Each press of the button switches the settingszas shown below.ON OFFON Enables set SCHEDULEOFF Disable set SCHEDULENoteIf [SCHEDULE] is set to [ON], the setting for [STANDBYzMODE] is automatically set to [NORMAL] and cannot bechanged. Even if [SCHEDULE] is then set to [OFF] whenin this state, the setting of [STANDBY MODE] remains at[NORMAL].How to assign a programJWith [SCHEDULE] switched to [ON],1 )press button.The [SCHEDULE] screen will be displayed.zSelect and assign program to each day2 )of week.Press ▲▼ to select a day of week and pressz◄► to select a program number.You can set the program from No.1 to No.7.z“- - -” indicates that the program number hasnot been set yet.How to set a programJYou can set up to 16 commands to each program.On the [SCHEDULE] screen, press ▲▼1 )to select [PROGRAM EDIT].Press ◄► to select a program number2 )to be set (Program 1 to Program 7) andpress the button.Press ▲▼ to select a command3 )number (01 to 16) and press the button.You can change the page using ▲▼.zPress ▲▼ to select [TIME] or4 )[COMMAND] and change the settingaccording to the instructions of themenu.Press the button after selecting thez[COMMAND], and you can set detailed settings.TIME Set the time at which the commandwill be executed using ▲▼ buttons.COMMANDSelect a command to execute at theset time from the following.POWER ON•STANDBY•AV MUTE ON•AV MUTE OFF•INPUT•COMPUTERINPUT VIDEO•INPUT S-VIDEO•INPUT DVI-I•INPUT HDMI•INPUT•NETWORKLAMP POWER•NORMALLAMP POWER•ECOSIDE BY SIDE•MODE OFF*1SIDE BY SIDE•MODE ON*1IN STANDBY•MODE (AUDIO)ONIN STANDBY•MODE (AUDIO)OFFVOLUME•PT-FW430U only*1 :Press ▲▼ to select [STORE] and5 )press the button.NoteIf you try to register a setting that would cause the lamp tozflash for a short time, an error message will be displayed onthe screen. Set the [TIME] and [COMMAND] again.If multiple commands have been set for the same time,zthey are executed in chronological order starting from thesmallest command number.The setting time operates under the local time.z(Æpage 62)If an operation is executed with the remote control orzcontrol panel of the projector or with a control commandbefore the command set in the schedule is executed, thecommand set with this function may not be executed.