Panasonic PT-LB90NTEA Operating Instructions Manual

Also see for PT-LB75VE: Brochure & specs Operating instructions

Contents

Panasonic PT-LB90NTEA Operating Instructions Manual Manual pdf 41 page image

PROJECTOR SETUP menuENGLISH - 41 SettingsPROJECTOR SETUP menuNavigating through the MENU (Æpage 29) , selectPROJECTOR SETUP from the main menu andthen select the required item from the sub-menu.Set the selected item with◄►buttons.zRemote control Control panelSTATUSYou can check the using status of the projector.SIGNALJNAME: Name of input signalzFREQUENCY: Scanning frequency of inputzsignalRUNTIMEJPROJECTOR: Display current usage time ofzprojectorLAMP: Display current usage time of lampzNO SIGNAL SHUT-OFFIf no image signal is input for the time set with thetimer, the projector will enter into standby modeautomatically.Change setting Change settingDISABLE NO SIGNAL SHUT-OFF is disabled15 - 60 MIN. Timer can be set in intervals of 5minutesINITIAL START UPYou can set the starting method when the mains plugis connected to mains socket.Change setting Change settingLAST MEMORYProjector starts from the last imagebefore the mains plug wasdisconnectedSTANDBY Projector starts in the standbymodeON Projector starts immediatelyINSTALLATIONWhen installing the projector, select the projectionmethod according to the projector position.(Æpage 18)Change setting Change settingFRONT/DESKSetting on a desk/floor andprojecting from frontFRONT/CEILINGMounting in the ceiling with a ceilingmount bracket (sold separately) andprojecting from frontREAR/DESKSetting on a desk/floor and projectingfrom rear (Translucent screen isrequired)REAR/CEILINGMounting in the ceiling with a ceilingmount bracket (sold separately) andprojecting from rear (Translucentscreen is required)HIGH ALTITUDE MODEIf you use the projector at high elevation, the HIGHALTITUDE MODE setting need to be ON to set thefan speed high.Change setting Change settingOFF For use in normal environmentON For use at high altitudeRemarksAt 1 400 -2 700 m (4 593 - 8 858 ft) sea level, thezsetting must be ON.The loudness of fan noise depends on thez HIGHALTITUDE MODE setting.