16- ENGLISHPreparationAbout Your ProjectorRemote control(1) ButtonExecute the setting of Auto setup in the setting.menu. (Æpage 47)(2) Input Selection Buttons: ,These buttons are used to select the input signal.(Æpage 30)(3) ▲▼◄► Buttons, Navigate the MENU display.(Æpage 33)(4) ButtonSelect a screen mode. (Æpage 45)(5) Open or close the On-Screen Menu. (Æpage 33)(6) ButtonPause the projected image tentatively. (Æpage 31)(7) ButtonTemporarily turn off the image on the screen.(Æpage 31)(8) ButtonsZoom in and out the images.(9) <> ButtonTurn the projector on or off. (Æpage 26)(10) ButtonCorrect keystone distortion. (Æpage 30)(11) ButtonOperate the information function. (Æpage 31)(12) ButtonSelect a lamp mode. (Æpage 31)(13) ButtonOperate the [P-timer] function. (Æpage 31)(14) ButtonSelect the image mode. (Æpage 32)(15) Remote control signal emitterAttentionDo not drop the remote control.zAvoid contact with liquids.zDo not attempt to modify or disassemble the remotezcontrol.NoteThe remote control can be used within a distance ofzabout 7 m (23.0 ft) if pointed directly at the remote controlsignal receiver. The remote control can control at anglesof up to ± 30 ° vertically and ± 30 ° horizontally, but theeffective control range may be reduced.If there are any obstacles between the remote controlzand the remote control signal receiver, the remote controlmay not operate correctly.You can operate the projector by reflecting the remotezcontrol signal on the screen. The operating range maydiffer due to the loss of light caused by the properties ofthe screen.When the remote control signal receiver is lit with azfluorescent light or other strong light source, the projectormay become inoperative. Set the projector as far fromthe luminous source as possible.(1)(9)(2)(4)(5)(6)(8)(7)(14)(13)(12)(11)(10)(3)(15)
