ENGLISH -15PreparationAbout Your ProjectorRemote control(1) ButtonExecute the setting of Auto setup in the [setting]menu. (Æpage 50)(2) Input Selection Buttons: ,, .These buttons are used to select the input signal.(Æpage 31)(3) ▲▼◄► Buttons, Navigate the MENU display. (Æpage 34)(4) ButtonSelect a screen mode. (Æpage 46)(5) Open or close the On-Screen Menu. (Æpage 34)(6) ButtonPause the projected image and sound tentatively.(Æpage 32)(7) ButtonTemporarily turn off the image on the screen.(Æpage 32)(8) ButtonsZoom in and out the images. (Æpage 33)( 9 ) ButtonsAdjust the volume of the speaker. (Æpage 33)(10) <> ButtonTurn the projector on or off. (Æpage 27)(11) ButtonCorrect keystone distortion. (Æpage 31)(12) ButtonOperate the [information] function. (Æpage 32)(13) ButtonSelect a lamp mode. (Æpage 33)(14) ButtonOperate the [P-timer] function. (Æpage 33)(15) ButtonSelect the image mode. (Æpage 33)(16) ButtonMute the sound. (Æpage 33)(17) Remote control signal emitterAttentionDo not drop the remote control.zAvoid contact with liquids.zDo not attempt to modify or disassemble the remotezcontrol.NoteThe remote control can be used within a distance ofzabout 7 m (22.97 ft) if pointed directly at the remotecontrol signal receiver. The remote control can control atangles of up to ± 30 ° vertically and ± 30 ° horizontally,but the effective control range may be reduced.If there are any obstacles between the remote controlzand the remote control signal receiver, the remote controlmay not operate correctly.You can operate the projector by reflecting the remotezcontrol signal on the screen. The operating range maydiffer due to the loss of light caused by the properties ofthe screen.When the remote control signal receiver is lit with azfluorescent light or other strong light source, the projectormay become inoperative. Set the projector as far fromthe luminous source as possible.(1)(10)(2)(4)(5)(6)(8)(7)(9)(16)(15)(14)(13)(12)(11)(3)(17)
