Panasonic PT-LX26HE Operating Instructions Manual

Also see for PT-LW25HE: Operating instructions

Contents

Panasonic PT-LX26HE Operating Instructions Manual Manual pdf 61 page image

ReplacementENGLISH - 61 MaintenanceJ Lamp unitThe lamp unit is a consumable component. You can check the total usage time using Lamp runtime in the[Information] menu on page 57.It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer.Consult your dealer to purchase a replacement lamp unit (ET-LAL100).CAUTION:■ Do not replace the lamp unit when it is hot. (Wait at least 45 minutes after use.)The inside of the cover can become very hot, take care to avoid burn injuries.Notes on the replacement of the lamp unitJThe luminous source of the lamp is made of glass and mayzburst if you hit it against a hard surface or drop it.Please handle with care.A Phillips screwdriver is required for replacement of thezlamp unit.When replacing the lamp unit, be sure to hold it by thezhandle.When replacing the lamp because it has stoppedzilluminating, there is a possibility that the lamp may bebroken.If replacing the lamp of a projector which has been installedzon the ceiling, you should always assume that the lamp is broken, and you should stand to the side of thelamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when thelamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.The lamp contains mercury. Consult your local municipality or your dealer about correct disposal of usedzlamp units.AttentionDo not use other than designated lamp units.zThe part numbers of accessories and separately sold components are subject to change without notice.zWhen to replace the lamp unitJThe lamp unit is a consumable component. Brightness decreases according to duration of usage, soperiodical replacement of the lamp unit is necessary.When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on thescreen and indicator lights yellow. Replace the lamp with a new one promptly.Lamp run time On screenLamp replacement iconLAMP indicatorOver 3000 hours*Over 3200 hours*The message is displayed for 10 seconds. If youpress any button within the 10 seconds, the messagedisappears.If the power is turned on without replacing the lamp,the power automatically turns off after approximatelyten minutes to prevent the malfunction of the projector.Lights in yellow (even instand-by mode).* 3200 hours of use is a rough guideline, but is not a guarantee. The lamp run time differs depending on thesetting of "Lamp power" menu.NoteThe Lamp replacement icon will not appear when the [Display] function is set to [Off ] (z Æpage 51), or during[Freeze] (Æpage 32), or [AV mute] (Æpage 32).