Remote control operation 40 - ENGLISH Basic Operation Switching the input The input for projection can be switched. button Press the input selection (, , , and ) buttons on the remote control. Switches to computer signal input mode. Switches to component (YC B C R / YP BP R ) signal input mode. S-VIDEO> Switches to S-video/video signal input mode. If either of the input modes has already been selected, switches to another input mode. Switches to HDMI signal input mode. If either of the input modes has already been selected, switches to another input mode. Note z Each time you press the the settings change as follows. ( page 21) [HDMI 1] [HDMI 2] [COMPUTER] [VIDEO] [S-VIDEO] [COMPONENT] Using the Automatic setup function During signal input from a computer, [SHIFT], [DOT CLOCK], and [CLOCK PHASE] can be adjusted automatically. button Press the button on the remote control. Note z During HDMI signal input, only [SHIFT] is adjusted automatically. z The input search is activated when there is no signal. (When [SIGNAL SEARCH] ( page 62) is set to [ON]) z When signals exceeding the dot clock 162 MHz are input, [DOT CLOCK] ( page 55) and [CLOCK PHASE] ( page 55) cannot be set automatically. z When you activate the auto setup function on images with blurred edges or dark images, operation may automatically stop. In this case, switch to a different image and press the SETUP> button again. z [AUTO SETUP] is displayed on the screen while the image is adjusted automatically. Previous Next 
