Panasonic PT-LZ370E Operating Instructions Manual

Contents

[PROJECTOR SETUP] menu66 - ENGLISHSettings[LAMP POWER]You can switch the electric power of projector lamp.Set the lamp power to meet the environment andpurpose of projection.1) Press ▲▼ to select [LAMP POWER].2) Press ◀▶ to switch [LAMP POWER].▶z The setting will change as follows each timeyou press the button.[NORMAL] [ECO][NORMAL] When high brightness is needed[ECO] When high brightness is notneededNotez The [ECO] mode can reduce power consumptionand operation noise.z The selection made here is reflected to theindication of the “ECO setting level” in the “MultiProjector Monitoring & Control Software” installedfrom the supplied CD-ROM.[LAMP RUNTIME]You can display the lamp usage time (convertedvalue).Attentionz When replacing the lamp, follow the “Replacing thelamp unit” ( page 102) and reset the lamp usagetime (converted value) to 0.Notez When the lamp unit has reached the end of its life,the lamp usage time (converted value) is indicatedin red and gray. Refer to “When to replace the lampunit” ( page 101) for details about the lifespan.[SCHEDULE]You can set the command execution schedule foreach day of the week.1) Press ▲▼ to select [SCHEDULE].2) Press ◀▶ to switch [SCHEDULE].▶z The setting will change as follows each timeyou press the button.[OFF] [ON][OFF] Disables the set schedule.[ON] Enables the set schedule.Notez If [SCHEDULE] is set to [ON], the settingfor [STANDBY MODE] ( page 68) in [ECOMANAGEMENT] is automatically set to [NORMAL]and cannot be changed. Even if [SCHEDULE] isthen set to [OFF] when in this state, the setting of[STANDBY MODE] remains at [NORMAL].▶■ How to assign a program3) Select [ON] in Step 2), and press the button.▶z The [SCHEDULE] screen is displayed.4) Select and assign program to each dayof week.▶z Press ▲▼ to select the day of week, and press◀▶ to select a program number.▶z You can set the program from No.1 to No.7.“- - -” indicates that the program number hasnot been set yet.▶■ How to set a programYou can set up to 16 commands to each program.3) Select [ON] in Step 2), and press the button.4) Press ▲▼ to select [PROGRAM EDIT].5) Press ◀▶ to select a program numberto be set ([PROGRAM 1] to [PROGRAM7]) and press the button.6) Press ▲▼ to select a commandnumber (01 to 16), and press the button.▶z You can change the page using ▲▼ .