Panasonic PT-LZ370E Operating Instructions Manual

Contents

[NETWORK] menuENGLISH - 87 Settings▶■ [E-mail set up] pageAn E-mail message can be sent to the E-mail address setup in advance (up to two addresses) when theproblem occurred or the lamp usage time reached the specified value.Click [Detailed set up] → [E-mail set up].(1)(2)(3)(4)(5)(6)(1) [ENABLE]Select [ENABLE] when using the E-mail function.(2) [SMTP SERVER NAME]Enter the IP address or the server name of the E-mailserver (SMTP). To enter the server name, the setup of theDNS server is required.(3) [MAIL FROM]Enter the E-mail address of the projector. (Up to 63characters in single byte)(4) [MEMO]You can enter information such as the location of theprojector that notifies the sender of the E-mail. (Up to 63characters in single byte)(5) [MINIMUM TIME]Change the minimum intervals for the temperature warningmail. The default value is 60 minutes. In this case, anotherE-mail will not be sent for 60 minutes after sending thetemperature warning mail even if it reaches the warningtemperature.(6) [INTAKE AIR TEMPERATURE]Change the temperature setting for the temperaturewarning mail. A temperature warning mail is sent when thetemperature exceeds this value.(2)(1)(1) [E-MAIL ADDRESS 1]Enter the E-mail address to be sent.(2) Settings of the conditions to send E-mailSelect the conditions to send E-mail.[MAIL CONTENTS]:Select either [NORMAL] or [SIMPLE].[ERROR]:An E-mail message is sent when an error occurred inthe self-diagnosis.[LAMP RUNTIME]:An E-mail message is sent when the remaining lampusage time has reached the value set at the right field.[INTAKE AIR TEMPERATURE]:An E-mail message is sent when the intake airtemperature has reached the value set at the abovefield.[PERIODIC REPORT]:Place a check mark on this when E-mail is to be sentperiodically.It will be sent on the days and time with the check mark.