Panasonic PT-P1SDE Operating Instructions Manual

Also see for PT-P1SDE: Service manual Service manual

POWERAUTOSETUPINPUT MENUSHUTTERVOLUMEENTERROTATERETURNENTERSTD%E NGLISH -29 Basic operationTurning off the power#, $ POWER buttonPOWER button on the projectorPOWER button statusRed Illuminated The projector is in standby mode and image projectionis possible by pressing the POWER button.A picture is being projected.The lamp is cooling down after the power has beenturned off or while direct power off function isoperating.The projector is preparing for projection after thepower has been turned on while the POWER buttonon the projector is illuminated orange. (After a shortperiod, a picture will be projected.)The projector is preparing for projection after thepower has been turned on while the POWER buttonon the projector is illuminated red. (After a shortperiod, a picture will be projected.)FlashingIlluminatedIlluminatedFlashingGreenOrangeProjector statusPress the POWER button.BThe “POWER OFF” confirmation screenwill be displayed.NOTE:B You can also turn off the power by holding down the POWER button forat least 0.5 seconds.NOTE:BPress any button other than the POWER button to cancel the “POWEROFF” screen.BThe “POWER OFF” screen will disappear in five seconds.#%P O W E R O F F[ P O W E R ] O KMains leadDirect power off functionYou can disconnect the mains lead during projection or immediately afteruse and move the projector. The cooling fan will operate by the internalpower supply to cool down the lamp.B When this function is used, it may take more time for the lamp to turn backon again compared to when the lamp cools down with the mains leadconnected.B Do not put the projector in the softcase while the POWER button on theprojector is illuminated.Disconnect the mains lead after the POWERbutton on the projector illuminates red.28-ENGLISHCAUTIONIf not using the projector for an extended period of time, disconnect themains plug from the mains socket.B If dust builds up on the mains plug, the resulting humidity may damage theinsulation, which could result in fire.B This projector continues to draw approximately 3 W of power even whenthe power is turned off.Press the POWER button again.BThe lamp unit will switch off and the picture will stop being projected.(The POWER button on the projector will illuminate orange while thecooling fan is still operating.)$NOTE:B Do not disconnect the mains lead while the files in the SD memory cardare being played back.