Panasonic PT-RZ120BEJ Operating Instructions Manual

Also see for PT-RZ120: Operating instructions Operating instructions

Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 135Notef To set the date and time automatically, the projector must be connected to the network.f If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is set to [ON], [NTP SYNCHRONIZATION] will return to[OFF]. If [NTP SYNCHRONIZATION] is set to [ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].f Access the projector via a web browser to set the NTP server. Refer to “[Adjust clock] page” (x page 170) for details.f The [TIME ZONE] setting is reset to the factory default when the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL USER DATA]is executed. However, the date and time based on the local date and time setting (Coordinated Universal Time, UTC, Universal Time,Coordinated) will be maintained without being initialized.f The replacement of the battery inside the projector is required when the time goes out of alignment right after correcting the time. Consultyour dealer.[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 135) or “How to set aprogram” (x page 135) for how to set the schedule.Notef When [SCHEDULE] is set to [ON] while the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], the [STANDBY MODE]setting is forcibly switched to [NORMAL], and the setting cannot be changed to [ECO]. The [STANDBY MODE] setting will not return tooriginal even if [SCHEDULE] is set to [OFF] in this condition.How to assign a program1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Select and assign a program to each day of week.f Press as to select the day of week, and press qw to select a program number.f You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.How to set a programSet up to 16 commands to each program.1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.3) Press as to select [PROGRAM EDIT].4) Press qw to select a program number, and press the button.5) Press as to select a command number, and press the button.f You can change the page using qw.6) Press asqw to select [TIME], and press the button.f The projector is in the adjustment mode (the time is blinking).7) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set atime, and then press the button.8) Press asqw to select [COMMAND].