Panasonic SC-HT892 Operating Instructions Manual

RQT88047Simple Setup∫ Preventing the speakers from falling≥ You will need to obtain the appropriate screw eyes to match thewalls or pillars to which they are going to be fastened.≥ Consult a qualified housing contractor concerning theappropriate procedure when attaching to a concrete wall or asurface that may not have strong enough support. Improperattachment may result in damage to the wall or speakers.∫ Attaching to a wallYou can attach the front speakers to a wall.≥ The wall or pillar on which the speakers are to be attachedshould be capable of supporting over 15 kg per screw. Consult aqualified building contractor when attaching the speakers to awall. Improper attachment may result in damage to the wall andspeakers.≥ When mounting the speakers to a wall, we recommend using astring (not included) to prevent it from falling.1 Drive a screw (not included) into the wall.2 Fit the speaker securely onto the screw(s) with the hole(s).Reattaching the speaker cable to the stand1 Remove the two screws from the stand, and remove the metal cover.2 Pull the cable out about 40 cm from the hole in the metal cover, andinsert the plastic cover.3 Insert the metal cover so it does not disturb the cable and close tightlywith the two screws.String (not included)Thread from the wall to the speaker and tie tightly.Rear of the speaker WallApprox.150 mmScrew eye(not included)Speaker installation optionsPreparation for front speakers1 Pull down the longer part of the cable to release the cable fromthe groove inside the stand, and then pull the speaker cable outfrom the stand.2 Feed the cable into the bottom of the speaker and through the slot atthe rear.3 Connect the cable (➜ page 6).‰7.5 to 9.5 mm5.0 to 7.0 mmWall or pillar‰4.0 mm255 mm320 mmIn this position, thespeaker will likelyfall if moved to theleft or right.Move the speakerso that the screwis in this position.e.g.ScrewMetal coverScrewPlastic coverApprox. 40 cmAssembling the front speakers