663-5 Auxiliary Output (Non-safety Output)This device incorporates the auxiliary output for the non-safety output.The auxiliary output is incorporated in the emitter.Auxiliary outputsettingNormal modeLockoutEmission halt input Control output (OSSD 1 / 2) statusLight received Light blockedNegative logic of OSSD(Factory setting) ON OFF ON ONDo not use the auxiliary output for the purpose of stopping the machine in whichthe SE4D series is installed. Failure to do so could result in death or serious in-jury.It is possible to switch the output operation for auxiliary output by using the handy controller (SE9Z-HC)(optional).3-6 External Device Monitor FunctionThis is the function for checking whether the external safety relay connected to the control out-put (OSSD 1 / 2) performs normally in accordance with the control output (OSSD 1 / 2) or not.Monitor the contacting point “b” of the external safety relay, and if any abnormality such as de-posit of the contacting point, etc. is detected, change the status of the device into lockout one,and turn OFF the control output (OSSD 1 / 2).● When the external device monitor function is set to be valid:Connect the external device monitor input wire (yellow-green) to the external safety relaywhich is connected to the control output 1 (OSSD 1) wire (black) and the control output 2(OSSD 2) wire (white).● When the external device monitor function is set to be invalid:Connect the external device monitor input wire (yellow-green) to the auxiliary output wire(yellow-green / black). At this time, the auxiliary output is set as [negative logic of control Incase the external device monitor input function is invalid, output (OSSD 1 / 2)] (factory set-ting) [Set through the handy controller (SE9Z-HC) (optional)]. The auxiliary output cannot beconnected to external devices.It is also possible to set the external device monitor function into “invalid” by using the handy controller(SE9Z-HC) (optional).ONOFFONOFFAuxiliary outputNegative logic ofOSSD20ms or lessLight receivedstatusControl output(OSSD 1 / 2)LightblockedLightreceived14ms or less 90ms or less20ms or less
