Watching TV19Watching TVVolume1 Turn power on Press for about 1 second. Mains power On / Off switch should be on. (p. 10) VIERA Connect introduction banner appearsEvery time you turn on the TV, this banner appears at the bottom of thescreen.You can access to VIERA Connect easily and enjoy the variouscontents. (p. 18) To remove this banner, leave for about 5 seconds or press anybuttons (except the buttons to access VIERA Connect). To set this banner display off [VIERA Connect Banner] (p. 38) The banner is subject to change.2 Select the mode You can also select the mode pressing the TVbutton repeatedly on the remote control or theTV (p. 10).3 Select a channelupdown orDVB channel position numbers run from 1 onwards.Analogue channel position numbers run in the ranges0 - 99. To select a more than two-digit channel positionnumber, e.g. 399 To select a channel using Information banner (p. 20)It is possible to confirm the channel name and programme information by using the Information banner beforechanging channels.1 Display Information banner if it is not displayed 2 While the banner is displayed, select the channelselect channelwatch To select a channel using TV Guide (p. 23)It is possible to confirm the channel and programme information by using the TV Guide (EPG) before changingchannels.1 Display TV Guide 2 Select the currentprogramme or channelselectaccess3 Select [View] (DVB)Das Erste19:30- 20:00View Timer ProgrammingselectwatchNote To watch pay-TV “Using Common Interface” (p. 53)