42Tuning and Editing Channels(DVB)Set DVB channel manually Manual TuningNormally use “Auto Setup” or “Update Channel List” to retune DVB channels.If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.All channels found will be added to the Channel List.●DVB-S:DVB-S Manual TuningTransponder FrequencyAnalogue Scan 21 68Signal Strength 0 10Signal Quality 0 1010847 MHzSatellite Astra 19.2° EPolarisation HorizontalSymbol Rate AutoService ID AutoModulation AutoPlease consult the received satellite●broadcasting companies for the setting.Set the satellite Set “Transponder Frequency”,“Symbol Rate”, “Polarisation”,“Modulation” and “Service ID”Searchselectsetselectsetabc defjklghi mnotuvpqrs wxyzDVB-C:Enter the frequency Searchabc defjklghi mnotuvpqrs wxyzDVB-C Manual TuningNo. Channel Name Type NewStoppedFree TV: 0FrequencySymbol RateService IDSignal Quality 0 10Signal Strength 0 10Pay TV: 0 Radio: 0474,00 MHzAutoAutoNormally set Symbol Rate and Service ID to “Auto”.●DVB-T:select channeladjust frequencySearchDVB-T Manual TuningAnalogue Scan 21 68No. Channel Name Type NewFree TV: 0 Pay TV: 0 Radio: 0 Data: 0StoppedSignal Strength 0 10Signal Quality 0 10Frequency 474,00 MHz[CH21]Set where the level of “Signal Quality” becomes the maximum.●Check DVB signal Signal ConditionSelects a channel and checks the DVB signal condition. To change the channel●DVB-S:A good Signal Strength is not an indication of suitablesignal for DVB reception. Please use the Signal Qualityindicator as follows:Signal Quality:Green bar● GoodYellow bar● PoorRed bar● Bad (Check the Terrestrial aerial, cable orSatellite dish)DVB-S Signal ConditionChannel Name 1 BBC 1 East (W)Signal QualitySignal StrengthSatellite0 100 10Astra 19.2° EBit Error Rate 0.00E+00Parameter 10847MHz, H, 22000kS/sDVB-C:DVB-C Signal ConditionChannel Name 70 CBBC ChannelSignal QualitySignal StrengthNetwork Name0 100 10WenvoeBit Error Rate 0.00E+00Parameter 802,00 MHz, 64 QAM, 6940 kS/sDVB-T:DVB-T Signal ConditionChannel Name 70 CBBC ChannelSignal QualitySignal StrengthNetwork Name0 100 10WenvoeBit Error Rate 0.00E+00Parameter [CH62] 802,00 MHzReduce the DVB-C signal AttenuatorIf the DVB-C signal is too strong, the interference may occur. In this case set to “On” to reduce the signalautomatically.This function is available only for DVB-C signal.●