Panasonic Viera TX-P50VT20B Operating Instructions Manual

Contents

Using Network Services●(DLNA / VIERA CAST / freesat) Advanced87WPS(Push button)■WPS(Push button)1) Please press the ‘WPS’ buttton on the accesspoint until its light flashes.2) When the light is flashing select ‘Connect’ onTV.If you are unsure, please check the instructionmanual of the access point.ConnectPress the WPS button on the access point until the light flashes.And then, press the OK button to connect the Wireless LAN Adaptor and theaccess point.Ensure that your access point supports WPS for this setup.●WPS: Wi-Fi Protected Setup●Search for access point■Access points found automatically are listed.Available Access PointsAccess Point A 11n(2.4GHz)11n(5GHz)SSIDNo. Wireless type Encrypt ReceptionAccess Point BAccess Point C 11n(5GHz)123Select your desired access pointselectaccess: Encrypted access pointTo search access points again● yellowFor the information of the●highlighted access pointTo set manually● redEncryption Key SettingConnection will be made with the following settings:-SSID : Access Point AAuthentication type : WPA-PSKEncryption type : TKIPPlease input the encryption key.Encryption keyAccess the encryption key input modeIf the selected access point is not encrypted, the confirmation screen will be●displayed. It is recommended to select the encrypted access point.Access Point SettingsEncryption keyA B C D E F G H I J K L M NU V W X Y Z 0 1 2 3 4 5 6a b c d e f g h i j k l m nu v w x y z ( ) + - . * _O P Q R S T7 8 9 ! : #o p q r s t1.!:# 2abc 3def4ghi 5jkl 6mno7pqrs 8tuv 9wxyz0Enter the encryption key of the access pointSet characters one by one StoreselectsetBACK/RETURNYou can set characters by using numeric buttons.● “Characters table for numeric buttons” (p. 104)Access Point SettingsEncryption key is set to:-XXXXXXXXSelect ‘Yes’ to confirm.Select ‘No’ to change.Yes NoSelect “Yes”selectconfirmTo re-enter the encryption key, select “No”.●WPS(PIN)■Available Access PointsAccess Point A 11n(2.4GHz)11n(5GHz)SSIDNo. Wireless type Encrypt ReceptionAccess Point BAccess Point C 11n(5GHz)123Select your desired access pointselectaccessEnsure that your access point●supports WPS for this setup.To search access points again●yellowFor the information of the●highlighted access pointTo set manually● redWPS(PIN)Please register the following PIN codes on theaccess point.PIN code : 12345678Select ‘Connect’ after entering and saving thesettings on the access point.ConnectEnter the PIN code to theaccess point, and then select“Connect”Manual■You can setup SSID, authentication type,encryption type, and encryption key manually.Follow the on screen instructions and setmanually.When you use 11n (5GHz) for the wireless●system between the Wireless LAN Adaptorand access point, please select “AES” forthe encryption type.Access Point SettingsPlease input the SSID.SSID XXXXXXXSSID SettingSSID is set to:-XXXXXXXSelect ‘Yes’ to confirm.Select ‘No’ to change.Yes NoAuthentication Type SettingsWPA2-PSKWPA-PSKShared keyOpenConnection will be made with the following settings:-SSID : XXXXXXXPlease select the authentication type.