Panasonic WJ-FS616C Operating Instructions Manual

Also see for WJ-FS616C: Operating instructions

-41-4-SEGMENTSCREEN9-SEGMENTSCREEN16-SEGMENTSCREEN1. Single Spot1. Repeat steps 1 and 2 above.2. Press the desired CAMERA button (1 - 16) corre-sponding to the picture you want to display. Theselected playback picture is displayed on the moni-tor screen.Note:• Blank channels are displayed in black.• While playing back quad pictures, the corre-sponding 4-segment picture is displayed, if theselected number is recorded as part of thequad picture. For instance, if #5 is selected, thequad picture of “5-6-7-8” is displayed.2. Single StillProceed as described in “Displaying the CameraPicture, 2. Single Still” on page 38.Confirm that the LED on the VCR/CAM button is lit.Note: The VCR does not enter pause mode whenthe playback picture is stilled.3. Electronic ZoomingProceed as described in “Displaying the CameraPicture, 3. Electronic Zooming” on page 39.Confirm that the LED on the VCR/CAM button is lit.4. Multi SpotProceed as described in “Displaying the CameraPicture, 4. Multi Spot” on page 39.Confirm that the LED on the VCR/CAM button is lit.Notes:• The 7-, 10-, and 13-segment multiscreen modesare not available in playback mode.• Segments assigned to channels where norecording takes place appear black.• The same channel cannot be displayed in multi-ple segments.If this attempt is made, only the picture of thechannel with the lowest number is displayed;the other segments appear black.• Do not press the MULTISCREEN SELECT but-ton while a 4-segment picture is played back,since this will cause picture disturbance.5. Multi StillProceed as described in “Displaying the CameraPicture, 5. Multi Still” on page 39.Confirm that the LED on the VCR/CAM button is lit.6. Spot or Multi SequenceProceed as described in “Displaying the CameraPicture, 6. Spot or Multi Sequence” on page 40.Confirm that the LED on the VCR/CAM button is lit.The LED on the VCR/CAM button lights up while theplayback picture is displayed.FUNCTIONCamera1Camera2Camera3Camera4Playback Camera2Camera3Camera4Note: The same channel cannot be displayed inmultiple segments.If this attempt is made, only the picture of thechannel with the lowest number is displayed;the other segments appear black. Displaying the Camera andPlayback PictureThe following procedures are not applicable tothe Multiscreen 2 Monitor.• One segment of the multiscreen for camera pic-tures can be assigned to playback.• This function is available with the 4-, 7-, 10- and 13-segment multiscreen modes.• The playback picture will be displayed in the upperleft segment of the multiscreen.1. Multi Spot1. Press the MULTISCREEN SELECT button. TheLED (green) on the button lights up.2. Press the VCR/CAM button to CAM position (LEDoff).3. Confirm that the 4-, 7-, 10- or 13-segment multi-screen is selected for the camera pictures.If not, press the MULTISCREEN SELECT buttonrepeatedly until the desired multiscreen appears.4. Press the FUNCTION button. The LED on the but-ton starts to blink.5. Select the playback channel you want to display bypressing the corresponding CAMERA button.The LED on the FUNCTION button lights, and theselected playback picture is displayed in the upperleft segment of the multiscreen.