Panasonic WJ-HDB502 User Manual

Panasonic WJ-HDB502 User Manual Manual pdf 30 page image

30The factory default setting is OFF.Refer to the Video Motion Detector Setting for furtherdetailed.9. Select either SPOT or OFF by clicking the button.The item lets you select the mode for displaying analarm on the Multiscreen Monitor.SPOT: The camera image that has activated the alarmis displayed in single spot mode.OFF: Ignores alarm activation and continues to displaythe images in the mode selected previously.The factory default setting is SPOT.10. Select either SPOT or OFF by clicking the button.The item lets you select the mode for displaying analarm on the Spot Monitor.SPOT: The camera image that has activated the alarmis displayed in single spot mode.OFF: Ignores alarm activation and continues to displaythe images in the mode selected previously.The factory default setting is SPOT. Alarm Port SettingThis item lets you designate the alarm input from theALARM port located on the rear of the Disk Recorder.1. Click the ALARM TERMINAL SETUP in the underneathof the ALARM SETUP window.The table as shown in the figure will appear on the dis-play screen.2. Select an alarm input channel (1CH - 16CH) in theALARM editing area by clicking the pulldown list.3. Select a camera number (CAM1 - CAM16) correspond-ing to the input in the CAMERA editing area by clickingthe pulldown list.4. Select the type of contact to meet the system require-ment in the INPUT editing area by clicking the pulldownlist.Normally Open: Accepts alarm input from NormallyOpen contacts.Normally Close: Accepts alarm input from NormallyClosed contacts.The factory default setting is Normally Open.5. Click the [SET] button to execute the selections and thecorresponding alarm channel will be replaced in thetable.6. Repeat the above steps 2 to 5 to designate the otherinput channels.7. When satisfied with all of the above steps, click theALARM SETUP display to return to the previous ALARMSETUP window. Video Motion Detector SettingThe following settings are available when the MotionDetector Board (Optional) is installed.This item lets you determine the mode of the motion detec-tor function when the Disk Recorder detects a motion onthe video image.Notes:• Make sure that the VIDEO MOTION DETECTION is setto ON in the ALARM SETUP window previously.• When the detecting area is set small, the function maynot detect object.It is recommended that the areas and sensitivity levelsare made test before the settings.1. Click the VMD AREA SETUP in the underneath of theALARM SETUP window.The VMD AREA SETUP window as shown in the figurewill appear on the display screen.