Panasonic WJ-NV300K Installation Manual

Also see for WJ-NV300K: Operating instructions Quick reference guide Operating instructions

Panasonic WJ-NV300K Installation Manual Manual pdf 31 page image

31Alarm connectionWhen a signal output from the other device is supplied to the Alarm input 1 to 9 terminals (pin nos. 1 - 9), recording or an alarmaction will be performed in accordance with the settings.When an alarm device such as a buzzer, a lamp, etc., is installed outside, connect them to the Alarm output terminal (pin no. 21).Time and polarities of the ALARM/CONTROL connectorTerminal Activation time RemarksAlarm input 100 ms or more N.O.: L activeN.O.: H activeNetwork error output At an error occurrence until the period selected for "Error out-put duration" has passed*L activeAlarm reset input 100 ms or more L activeFace matching output The set time on the setup menu L activeHDD error output At an error occurrence until the period selected for "Error out-put duration" has passed*L activeCamera error output At an error occurrence until the period selected for "Error out-put duration" has passed* or the camera resetL activeRecorder error output At an error occurrence until the period selected for "Error out-put duration" has passed*L activeRecording error output At an error occurrence until the period selected for "Error out-put duration" has passed*L activeTime adjustment signal input Input: 100 ms or more L activeAlarm output The set time on the setup menu L active* The error output duration is configured on the "Advanced setup" menu - the "Maintenance" page - "System setup" of the setupmenu. (☞ Operating Instructions (PDF))Note:During "L active (Low active)", the logic will be implemented when the voltage level of signal is low.•During "H active (High active)", the logic will be implemented when the voltage level of signal is high.•(Alarm input 1)(Signal ground)Sensor Door securityswitch(Alarm input 9)* Attached when necessary(Signal ground)Alarming device2113 9 14 1Relays, etc.*ALARM/CONTROL(Alarm output)