Panasonic WJ-SX650 Series Operating Instructions Manual

Also see for WJSX650 - SWITCHER: Product catalog Operating instructions

Contents

Panasonic WJ-SX650 Series Operating Instructions Manual Manual pdf 67 page image

67Alarm Descriptions Alarm OccurrenceWhen this unit accept an alarm input signal (terminal alarm, camera alarm, recorder alarm, serial alarm, or video loss), analarm event (tour sequence, etc.) is activated automatically. Each alarm input signal is associated with an alarm event setting.(The setting activates the alarm input signal and alarm event.) Up to 1 024 alarm event settings are available. The alarm eventsetting is performed in "Alarm" – "Alarm Event" of WJ-SX650 Series Administrator Console.By performing the settings of "Alarm Event", the following events will be activated when this unit accepts an alarm input signal.• Alarm event information will be displayed on the associated monitors (Refer to p. 13 Monitor Display Information.)• Depending on the setting of "Display Mode", camera images will be displayed, or sequences will be activated on the asso-ciated monitors. In this document, these actions are mentioned as the alarm mode, and pictures displayed during thealarm mode is mentioned as alarm pictures.• Depending on the setting of "Recording Source (LCN)", event recording will be activated. (Recording will follow the com-mand alarm setting and event recording setting of recorder. Refer to the operating instructions of recorder for details.)• Depending on the setting of "Alarm Output", alarm output signal will be supplied from the video output board, and externalalarm devices (buzzer, etc.) can be activated.Notes:• To activate alarm output signals from the ALARM OUT 1/2 port, perform settings of No.1 to 64. No.65 and greater areassigned for serial commands.• To activate alarm output signals as a serial command, serial command settings are required. The settings are per-formed in "Communication" – "Serial Command" of WJ-SX650 Series Administrator Console.• ALARM indicators of all system controllers blink.• Up to 10 000 alarm records are saved chronologically. The latest 1 000 alarm records can be displayed as the alarm his-tory on the monitor. (Refer to p. 70 Alarm History Display.) The Alarm History can be downloaded from the PC to the unit.• Alarm information is notified to the PC in serial commands. The serial command setting is performed in "Communication" –"Serial Command" of WJ-SX650 Series Administrator Console.Terminal alarm settingNo.11(Dish) No.10 (Pot)No.1 (Entrance)SensorsystemAlarm Input 256Matrix Switcher WJ-SX 650650Alarm input signalfrom a sensorALARMTIMERHDD 2ERRORHDD 1ALARMSUSPEND ALARMRESETOPERATEMONITOR1MONITOR2159132610/014371115481216SEQSHIFT OSDPAN/TILTSTOP PLAY PAUSE REC - REC STOPZOOM/FOCUSTEXTCOPYDISK SELECTEL-ZOOMMARKLOGOUTIRISPRESET/AUTOA-BREPEATGOTOLASTLISTEDSEARCHBUSYSETUP/ESCSETREV– +FWDPULLDigital Disk RecorderWJ-HDPAN/TILTSLOWInfrared sensorPreset Position 1(Zooming in No.1 (Entrance))Monitor 5Terminal Alarm256This unitCamera 100PCAlarm Output 50Recorder 1Records the imageof Camera 100.(Recording followsthe command alarmsetting and eventrecording setting ofrecorder.)Notifies thealarm eventoccurrence.No. Display Mode Spot Monitor RecordingSource (LCN) Alarm OutputLCN Preset256 SPOT 100 1 5 100 50