5Basic operationThe operations in the setup menu are performed with the operation buttons after calling up the setup menu on the connected videomonitor.The description below explains how to operate the setup menu basically.Screenshots of WV-CF314LE are shown as an example.Screenshot 2The setup mode changes to “ENABLE”, and the setup menubecomes ready to be set. Step 3Move the cursor to the item to be set, and press the [SET]button.Screenshot 1Hold down the [SET] button for about 2 seconds to call up thetop screen of the setup menu. Step 1Press the [UP] or [DOWN] button to move the cursor to “END”.Step 2Press the [RIGHT] button to move the cursor to “SETUP”,and press the [SET] button to change the setup mode from“DISABLE” to “ENABLE”.MODEL WV-CF314LCAMERA ID OFFCAMERASYSTEMBACK-FOCUSEND SETUP DISABIESPECIALLANGUAGEMODEL WV-CF314LCAMERA ID OFFCAMERASYSTEMBACK-FOCUSEND SETUP ENABLESPECIALLANGUAGEScreenshot 3The selected setup screen in the setup menu appears on thescreen.Note:• If the top screen of the setup menu is called up with theoperation buttons, the setup mode is always “DISABLE” toprevent operation errors.To perform settings in the setup menu, change the setupmode to “ENABLE”.• The cursor is a reversely highlighted part.Step 4Perform the settings for each item.• Selection of setting item:Press the [UP] or [DOWN] button to move the cursor.• Change of settings:Press the [RIGHT] or [LEFT] button.• Display of advanced setup screen:Press the [SET] button when “ ” is attached to the targetsetting item.• Return to previous setup screen:Move the cursor to “RET” and press the [SET] button.• Return to the top screen:Move the cursor to “TOP” and press the [SET] button, todisplay the top screen of the setup menu.Step 5Move the cursor to “END” and press the [SET] button to returnto the camera image screen, or wait about 5 minutes and thesetup menu will automatically close.**CAMERA SETUP**SCENE1ALC/ELC ALCSHUTTER OFFAGC ON(LOW)SENS UP OFFWHITE BAL ATW1DNR HIGHAUTO2VMDRET TOP ENDD&N(IR) OFF