Note• “IR LED Light” can be used when “On” or “Auto2(IR Light)” is selected for “Day & Night(IR)”.• Adjust the “IR LED Light” settings according to factors such as the setting conditions or distance fromthe subject.[Intensity control]SPW631LSPW631LSPW611LSPW611LWhen “On” is selected for “Intensity control”, the intensity is controlled so that subjects in images are notoverexposed.Default: OnNote• “Intensity control” is only available when “On” or “Auto2(IR Light)” is selected for “Day & Night(IR)”, and“Off” is selected for “Super Dynamic”.• When “On” is selected for “Intensity control” and there is a bright part in an image, the entire imagemay be made darker. In this case, if you select “Off” for “Intensity control”, the image will becomebrighter.[White balance]Select a method of white balance adjustment from the following.White color can be adjusted by “Red gain” and “Blue gain”.• ATW1: Selects the automatic tracing white balance mode. The camera will constantly check the colortemperature of the light source and adjust the white balance automatically. Operating color temperaturerange is approx. 2,700 K to 6,000 K.• ATW2: Selects the automatic tracing white balance mode under a sodium lamp. The camera will adjustthe white balance automatically under a sodium lamp. Operating color temperature range is approx. 2,000K to 6,000 K.• AWC: Selects the automatic white balance control mode. This adjustment is suitable for a location wherea light source is stable. Operating color temperature range is approx. 2,000 K to 10,000 K.• Default: ATW1Note• Under the following conditions, color may not be faithfully processed. In these cases, select “AWC”.– When shooting a subject whose major part is a thick color– When shooting blue sky or sun at sunset– When shooting a subject whose luminance is too low• When “AWC” is selected, click the [Set] button.[Red gain]Adjust the red color of images.When the cursor is moved in the “+” direction, the red color will become thicker. When the cursor is moved inthe “-” direction, the red color will be thinner. Click the [Reset] button to reset the color to the default.• Default: 128[Blue gain]Adjust the blue color of images.When the cursor is moved in the “+” direction, the blue color will become thicker. When the cursor is movedin the “-” direction, the blue color will be thinner. Click the [Reset] button to reset the color to the default.• Default: 128[DNR]The digital noise reduction function reduces noise automatically under the condition of low illuminance. Selectan effect level “High” or “Low” for the digital noise reduction.• High: High DNR, increases afterimageOperating Instructions 10311 Configure the settings relating to images and audio [Image/Audio]
