The settings and the HTML data of the camera can be initialized and reboot of the camera can be performedon this page.[Reset to the default (Except the network settings)]Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.It is impossible to operate the camera for about 3 minutes after the initialization.[Load the default HTML files (setup menu).]Click the [Execute] button to reset the HTML files to the default.It is impossible to operate the camera for about 3 minutes after the initialization.[Reset to the default and load the default HTML files.]Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that thenetwork settings will not be reset.It is impossible to operate the camera for about 3 minutes after the initialization.[Reboot]Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutesafter rebooting the camera.Note• To initialize the network settings (®page 153), turn off the power of the camera, then turn on the poweragain while holding down the INITIAL SET button on the unit, and keep the INITIAL SET button helddown for about 5 seconds. Wait about 3 minutes after releasing the button. The camera will start upand the settings including the network settings will be initialized. Do not turn off the power of the unitabout 3 minutes after turning on the power.• The notification function allows users to provide the notification of the error to the specified destinationE-mail address and an original alarm destination when an error such as no SD memory card insertionafter the reboot or a locked SD memory card insertion occurs. (®page 158, page 140)18.5 Settings data/backing up or restoring logs[Data]Click the [Data] tab of the “Maintenance” page. (®page 41, page 43)202 Operating Instructions18 Maintenance of the camera [Maintenance]
