Paradyne Hotwire 8784 User Manual

Also see for Hotwire 8784: Installation instructions

Contents

Paradyne Hotwire 8784 User Manual Manual pdf 65 page image

6. Messages and Troubleshooting8784-A2-GB20-30 February 2001 6-3Device MessagesThe Device Messages in Table 6-1, Device Messages, listed in alphabetical order,may appear in the messages area at the bottom of the ATI screens.Table 6-1. Device Messages (1 of 2)Device Message What Message Indicates What To DoAccess level isOperator.Configuration isread-only.The operator requested thatconfiguration options beloaded, but does not haveauthority to edit them.If configuration options are to beedited, use a Login ID that hasAdministrator authority.Cannot Save – noLogin IDs with AccessAdministratorAll of the login IDs beingsaved have an access levelbelow Administrator.Change the access level of atleast one Login ID toAdministrator so thatconfiguration changes can bemade. (Operator-level userscannot make configurationchanges.) Save the Login IDs.Command Complete Action requested hassuccessfully completed.No action is needed.Invalid Character (x) A nonprintable ASCIIcharacter (x) has beenentered.Re-enter information using validcharacters.Invalid Password Login is required and anincorrect password wasentered; access is denied. Try again. Contact your systemadministrator to verify yourpassword.Invalid – Send PatternAlready ActiveA pattern test was already inprogress when the Start fieldwas selected. Allow test to continue. Select another test. Stop the test.Invalid –[Test] AlreadyActiveThe described test wasalready in progress whenanother selection was made. Allow test to continue. Select another test. Stop the test.Invalid TestCombinationA loopback or pattern testwas in progress when Startwas selected to start anothertest, or was active on thesame or another interfacewhen Start was selected. Wait until other test ends andmessage clears. Abort all tests from the Testmenu screen. Stop the test from the samescreen the test was startedfrom.IP address not inMCC subnetnnn.nnn.nnn.nnnThe Peer IP addressspecified is not in the samesubnet as the MCC.Enter an IP address that is inthe same subnet as the MCC.