Philips BDL4677XH User Manual

Also see for Signage Solutions BDL4677XH: Brochure & specs

BDL4677XH112.3.2. Inserting the batteries in the remote controlThe remote control is powered by two 1.5V AAA batteries.To install or replace batteries:1. Press and then slide the cover to open it.2. Align the batteries according to the (+) and (–) indications inside thebattery compartment.3. Replace the cover.Caution:The incorrect use of batteries can result in leaks or bursting. Be sure to follow these instructions:• Place “AAA” batteries matching the (+) and (–) signs on each battery to the (+) and (–) signs of the battery compartment.• Do not mix battery types.• Do not combine new batteries with used ones. It causes shorter life or leakage of batteries.• Remove the dead batteries immediately to prevent them from liquid leaking in the battery compartment. Don’t touch exposed battery acid, as it candamage your skin.NOTE: If you do not intend to use the remote control for a long period, remove the batteries.2.3.3. Handling the remote control• Do not subject to strong shock.• Do not allow water or other liquid to splash the remote control. If the remote control gets wet, wipe it dry immediately.• Avoid exposure to heat and steam.• Other than to install the batteries, do not open the remote control.2.3.4. Operating range of the remote controlPoint the top of the remote control toward the display’s remote control sensor(backside) when pressing a button.Use the remote control within the range which is shown in the following table.Operation Angle RC operational distanceθ= 0º (for H & V) ≥ 8mθ= 20º (for H & V) ≥ 5mθ= 45º (for H only) ≥ 2mNOTE: The remote control may not function properly when the remote controlsensor on the display is under direct sunlight or strong illumination, or whenthere is an obstacle in the path of signal transmission.POWERSMART VIDEOSOURCEPIPINPUTON/OFF CHANGEBRIGHTNESSCONTRASTDISPLAYAUTOADJUSTMUTEVOL UPVOL DOWNEXITMENUSETAUDIOSOURCEUSB MENUHVθ