Q-See QSC26408 User Manual

Contents

Q-See QSC26408 User Manual Manual pdf 105 page image

User Manual for Commercial Series Net DVRPage 105 Total 1218.2 Upgrade Mode1. Use client software to upgrade the firmware file. You do not need to use ftp serversoftware. Please refer to the client software user manual for detailed information.2. Use “FTP” function of “Upgrade” sub menu in “Utilities” menu. You need one host PCto run FTP server software and place firmware file (digicap), and make sure DVR andPC are in the same sub net.3. Use “USB” function of “Upgrade” sub menu in “Utilities” menu. Please make sure thefirmware file (digicap) is placed under root directory of USB flash memory.4. After you reboot DVR, if you can hear the startup sound, but can not see startup picture,you can input shell commands under HyperTerminal. You need one host PC to run FTPserver and HyperTerminal software, and make sure DVR and host PC are in the samesub net. Please use DTE cable to connect DVR will host PC.Step 1: Setup and run HyperTerminalThe parameters are: Baud rate: 115200bps, Data bit: 8 bits, Stop bit: 1 bit,Parity: No, Flow ctrl: None.Step 2: Press "ctrl" and "u" keys of the PC keyboard. Do not release them.Step 3: Switch the power supply of DVR off and on. In the HyperTerminal, thefollowing sentence appears: Please input [u/U] or [ESC] key, Release "ctrl" and "u"keys.Step 4: Press “u” key. In the message line of “IP address of NET DVR”, input any oneIP, just make sure DVR IP and FTP server IP are in the same sub net.Step 5: In the message line of “IP address of the FTP server”, input the FTP server IP.Step 6: In the message line of “Confirm? (y/n)”, press “y”. DVR will connect with thatFTP server, and download the firmware file (digicap) through the network. Please makesure FTP server and firmware file are setup and run correctly. After upgrade finishes,press any key to reboot DVR.