Q-See QSC26408 User Manual
                                                                                                                         | |
Contents
| 
User Manual for Commercial Series Net DVRPage 87 Total 1216.16 RS232 setupThere is one RS-232 port on DVR rear panel. In main menu, move “Active Frame” to“RS232” icon and perss【ENTER】key, you enter into “RS232” setup menu:RS232 menu descriptionRS-232 parameters: Including baud rate, data bit, stop bit, parity, flow control, etc.Work mode: The RS-232 can be used as “Console”, “PPP” or “Transparent Channel”.Console: Connect with PC serial port. You can use HyperTerminal or NetTerm to control it.PPP: Connect Modem, using PSTN to transfer video image.Transparent channel: Connect serial devices. Remote PC can control these serial devicesthrough network.PPP Mode: Only used when work mode is “PPP”. There are two options: “Active” and“Passive”. “Active” means DVR will diaup through PSTN. “Active” function is not available.“Passive” means DVR will wait for dialup.Callback mode: Only used when work mode is “PPP”. There are two options: “By Dialer”and “Preset Tel’. This function is not currently available.Remote IP: Only used when work mode is “PPP”. This IP is defined for remote PC that willconnect DVR through PSTN.Local IP: Only used when work mode is “PPP”. This IP is defined for DVR.Mask: Only used when work mode is “PPP”. Remote IP and Local IP are in the same subnet.Username, password and Verify password: Only used when work mode is “PPP”. Used for |
Related manuals for Q-See QSC26408
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine