C–Flash UpdateQLogic Adapter Flash Update — LinuxC-8 NE0154601-00 A To perform updates simultaneously from two different directory trees, typethe following commands from two separate directory trees. In thesecommands, n represents two different port numbers, for example, “LocalArea Connection 4” and “Local Area Connection 5” (thequotation marks are required). c:\[version]-a\utils\ nxflash.exe -i “Local AreaConnection n” --all (first QLogic adapter) c:\[version]-b\utils\ nxflash.exe -i “Local AreaConnection n” --all (second QLogic adapter)QLogic Adapter Flash Update — LinuxThis section provides information on how to perform a Flash update in Linux. Notethat the QLogic adapter is shipped with a default Flash version.Using the Flash UtilityWhen invoking the nxflash utility, use the following syntax:% ./nxflash -i [n] [command]In this command, the [n] indicates the QLogic adapter device number (0, 1, etc).Along with the interface type (-i in the nxflash command syntax), additionalcommands ([command] in the nxflash command syntax) are listed inTable C-2.Table C-2. Flash Utility Commands — LinuxCommand Definition Description-l--listList devices This command shows all QLogic devicesinstalled.-i--interfaceInterface This command specifies the interface type(0, 1, 2, etc.).--info Information This command prints board informationsuch as the board type, chip revision, serialID, firmware version, BIOS version, MACaddress, etc.-a--allFlash update This command performs a completeupdate of the BIOS and firmware. Thiscommand is used when the default ROMimage is used.
