10.5 Entering Configuration Information10-22 501801 Rev. 07-01-197. In the Carousels section of the page, make sure that the correct information isdisplayed for an attached MEM.8. If you changed the hardware configuration during installation or if theinformation in the file is incorrect for any other reason, enter the correctinformation.9. If the hardware configuration is accurate, press Done.10.5 Entering Configuration InformationAfter connecting the XLS to a network and logging in, you can enter basic configurationinformation for the library, including the following:• Network address (see Section 10.5.2 on page 10-23)• Contact names and addresses (see Section 10.5.3 on page 10-25)• Administrator name and address (see Section 10.5.4 on page 10-26)• Target IDs for the HBAs and the tape drives (see Section 10.5.5 on page 10-29).10.5.1 Accessing the Configuration PortletTo access the Configuration portlet, follow these steps:1. If necessary, press the Home button in the upper right corner of any page toreturn to the Home page.Important: Section 10.2 on page 10-4 provides instructions forobtaining the values for Theta and X.
