XLS Library Installation Manual 3-13 Unpacking the XLSThis chapter provides instructions for unpacking the XLS library and components. Thischapter is intended as a supplement to the XLS Library Site Planning Guide (501804).Required tools and equipment: Obtain the following:• Phillips screwdriver• 1/2-inch socket or open-end wrench• 5/16-inch hex wrench (included in the accessory box)• ScissorsProcedure overview: Unpacking the XLS involves the following steps:• Inspecting the shipment (see Section 3.1)• Unpacking the XLS (see Section 3.2 on page 3-3)3.1 Inspecting the ShipmentBefore unpacking the cartons, inspect the entire shipment, as follows:1. Check the packing lists on each container to ensure you have received allrequested equipment, including– Correct model of Library Resource Module (LRM)– Media Expansion Module (MEM2), if ordered– Expansion pod, if ordered– Correct number and type of tape drive assemblies and drive filler assemblies– Other accessories, including cartridges and barcode labelsWARNING!Not including tape drives or cartridges, the LRMs weigh up to 590 lbs(268 kg). To avoid injury or equipment damage, use a pallet jack orforklift when moving the packaged XLS.
