5 Installing a MEMXLS Library Installation Manual 5-97. The direction of the bolts is as follows:– When the MEM is to the left of the LRM (as viewed from the front):• All six bolts go from the LRM to the MEM8. From the MEM accessory kit, obtain six 5/16 x 1/2-inch socket head screws andwashers.9. Insert the screws through their washers and into the holes.10. Tighten the screws with a 1/4-inch Allen wrench.5.6 Lowering the Leveling FeetTo lower the leveling feet on the MEM, follow these steps:1. Locate the four leveling feet on the MEM. See Figure 5-11Important: If the holes on the MEM do not align with the holes onthe LRM, adjust the leveling feet on the MEM (seeSection 5.6).Figure 5-11 Location of the four leveling feet on the MEMXLS-85000
