Quanmax KEMF-4010 User Manual

Contents

Quanmax KEMF-4010 User Manual Manual pdf 20 page image

Chapter 220KEMF-4010 User’sJumper SettingsTo ensure correct system configuration, the following section describes how to setthe jumpers to enable/disable or change functions. For jumper descriptions, pleaserefer to the table below .Table 2 Jumper ListLabel FunctionJP1 COM6 Signal / Power SelectionJP2 COM4 Signal / Power SelectionJP3 COM2 Signal / Power SelectionJP4 DIO Signal / Power SelectionJP5 Parallel Port Signal SelectionJP6 COM5 Signal / Power SelectionJP7 COM3 Signal / Power SelectionJP8 ATX/AT mode SelectionJP9 Clear CMOS SelectionJP11 Panel Power SelectionJP12 Backlight Power SelectionJP13 COM1 Signal / Power SelectionJP14 KB / MS Signal SelectionJP15 BL Signal SelectionTable 3 JP1, JP2, JP3, JP6, JP7, JP13, COM Port Signal / Power SelectionJumper Setting Function11-3 Short Pin 1 = +12V3-5 Short Pin 1 = +5V5-7 Short Pin 1 = +5V7-9 Short Pin 1 = DCD@RS232, TX-@RS422,DATA-@RS485 (Default)22-4 Short Pin 9 = +12V4-6 Short Pin 9 = +5V6-8 Short Pin 9 = +5V8-10 Short Pin 9 = RI (Default)JP1,JP2,JP3,JP6,JP7 : Pitch: 2.54mm NY 6T[YIMTEX 3362*05SANGR]JP13: Pitch: 2.54mm [YIMTEX 3322*05SAGR(6T]Cable : 0C501P040926000L COM Port cable, 10-pin 2.54mm to DB-9 connector with bracket, L=26cmTable 4 JP4, DIO Signal / Power SelectionJumper Status1-2 +5V(Default)2-3 +12VPitch: 2.54mm [YIMTEX 3321*03SAGR(6T)]