TroubleshootingKiaro! 200 User Guide 101Printer Not Operating CorrectlyPower OffPrinter Does Not Start or Printer Stops During Print JobsCheck Point SolutionMain power switch is at the off position. Press main power switch to the on posi-tion.Printer power cord unplugged. Make sure that the power cord isplugged in completely.Power supply not providing power. Connect another device to the powersupply to confirm that the outlet is pro-viding power. If you cannot restore theprinter to normal operation, contactQuickLabel Support.Check Point SolutionUpper unit, ink tank door, or mainte-nance cartridge door open.Close the upper unit, ink tank door, ormaintenance cartridge door and ensureit is closed tightly.Printer is not connected to the com-puter.Check the USB cable and make surethat it is connected to the printer and thecomputer.Media is not loaded correctly. Load media correctly.The ink tanks are not installed correctly. Check the ink tanks and make sure thatthey are installed correctly.The printer driver is not selected on thecomputer.Make sure that the Kiaro! 200 printer isselected when you start the print job.Print data contains an image with alarge capacity.If you see the STATUS LED flashing,this means data is processing. Wait forthe processing to finish.The printer has been printing for a longperiod.If the printer prints for a long period theprinthead may overheat. To protect theprinthead, the Status Monitor will displaya printhead overheated message andstop the print job. Just wait for the print-head to cool down.
